Electronics
If any toy car which uses electricity to run and
you are tired of it, then this is the right thing to do!!!
You can make a real windy fan out of it!!!
Note: Take help from an elder.
Put the car up-side down and open the screws anti clock wise.
When the screws are opened put them in a safe place.
Now be very careful and hold the car's base and pull the chasis out of the car.
Now you will see a motor near the car's tires. (if you don't know what a motor is ask an elder)
If the motor is locked with screws open them all.
Now again be very careful when you take out the motor.
There will be two wires attached to the motor. Don't pull them, cut them from the middle of the switch and the motor.
Take the switch out also and get more wires.
Put the car's body on its base and close the screws clock wise.
Collect more wires, a small plastic fan, a sticky tape and a 1.5 V battery cell.
Now attach one wire of the motor to the one point of the switch with a tape.
Then attach the other wire of the motor to the cell and be sure that the switch is off.
Attach the other wire coming from second point of the switch to the second terminal of the cell with the tape.
Put the plastic wings of the fan on the motor's rotating rod.
Take the motor in your hand and put on the switch.
If the fan is moving clock wise then to make it run anti- clock wise, change the polarity of the wires on the cell.
Your fan is ready to be used!